3D printed firearms take another step forward with the Shuty-MP1, made up of a mix of Glock parts and printed plastics.
previous
next
One thought on “Shuty-MP1”
Comments are closed.
All about guns, legislation and politics in New York
3D printed firearms take another step forward with the Shuty-MP1, made up of a mix of Glock parts and printed plastics.
Comments are closed.
Very nice. When I was a kid, could make a 1 shot with a door latch, bolt, nail, rubber band, and car antenna. Got .22 shorts out of the gallery rifles at the old Time Square archade or Coney Island when the guy wasnt looking(they had .22 short gallery rifles in NY – it was still America back then – EVEN NY LOL). You could also drill out a cheap starter pistol. Jacob, u may be old enough to remember this stuff LOL. DISCLAIMER: DO NOT DO THIS WITH MODERN LOADS!! IT WILL BLOW UP AND HURT YOU and or get you arrested! (I believe those old gallery .22 shorts were low pressure CB caps?)